HCDP Electronics Logo email info@hcdpelectronics.co.za
phone +27 12 804 1377


Products
Related Products

220VAC 180W True Sine Wave Inverter

Connector 2-pole 50A

Quattro USB

Ritar Deep Cycle AGM Battery
Power Panel MK4 R03
Product Code: HPP1 MK4 R03
Model: HPP1 MK4 R03
Discontinued

Product Information Technical Notes Product Documents Print
Product Information
Product Features

  • 220VAC to 12 Volt 12 Amp Multistage Lead-Acid Battery Charger with Fast and Trickle charge indicator.
  • AC charger optimised for Lead Crystal batteries
  • AC charger with battery temperature sensor to adjust battery charging voltage based on battery temperature.
  • Unique DC to DC 12V 12 Amp Charger (no need for a separate dual battery switch)
  • Digital Voltage and Current Monitor
  • Optional 180W 220VAC true sine wave inverter
  • Auto DC charger bypass when charging from vehicle (full 12A available to charge battery while fridge etc. runs directly from vehicles alternator)
  • DC to DC charger has auto ON and OFF vehicle voltage sensing switch
  • Battery under voltage lockout to prevent deep cycling and damage to battery
  • Integrated 270 Watt Solar Charge Controller with MPPC
  • LED charge source indicator
  • Integral thermostatically controlled cooling fan
  • Integrated 220VAC Earth Leakage unit and overload Circuit Breaker.
  • 1x 3-pin SA and 1x EURO 220VAC output sockets
  • 220/240VAC MultiPlug Outlet
  • Can operate from any combination of 220VAC, Battery or Solar Panel
  • Short circuit protection on all outputs
  • Supplied with mounting hardware 
  • Supplied with all connectors required
  • Easy to install
  • Warranty now 2 years from 2014
LED indicators
  • SP LED
    • turns green if charging from solar panel and if 220VAC charger is switched OFF
  • DC LED
    • turns green if charging from vehicle
  • AC LED
    • turns Amber if fast charging and charging current is more than 4A
    • turns Green if trickle charging and current is less than 4A but more than 2A
    • flashes Green at 1Hz if battery is fully charged and waiting to top up battery
    • flashes Red at 1Hz if battery is faulty and battery voltage remains below 9V
    • flashes Green and Amber alternatively at 1Hz if battery is not detected. This can happen if battery is not present, battery fuse is blown or if battery connection is faulty
    • blinks Red if temperature sensor fault occurs or if sensor is disconnected and defaults to 35�C
Battery Temperature Sensor
Place sensor close to battery to pick up battery temperature
Technical Notes
HPP1 MK4 R02
    
HCdP Power Panel MK4 with Digital Battery Monitor and Multiplug Outlet
    
Technical Notes

Power Panel
Operating ambient temperature-20°C to +45°C
Massgram
DimensionsWithout inverter 235(W)x235(D)x100(H) mm3
With inverter 235(W)x280(D)x100(H) mm3
220VAC Charger
Input voltage180VAC to 265VAC 40Hz to 70Hz
Input connectorStandard 3-pin kettle cord
Fully charged:Green LED flashes at 1 Hz
Trickle charge current2 to 4.5 Amp nominal (Green AC LED ON)
Fast charge current12 Amp Maximum (Amber AC LED ON)
Fast charge voltage14,4V +/- 0,1V @ 25°C
Trickle charge voltage13.8V +/- 0.1V @ 25°C
Temperature compensation:-11mV/°C
Vehicle DC Charger
Input voltage (Vehicle GND & POS)10.5VDC to 15VDC
Ignition sense switch ON> 13,3V
Ignition sense switch OFF< 12.5V
Input connectionVehicle GND, POS & Ignition (Black, Red & Yellow Power-Pole connector)
Charge voltage14.2V +/- 0.1V
Charging current12 Amp maximum with Ignition ON
Input current30A maximum
Drain from vehicle batteryZero Amp with ignition OFF
NoteThis DC to DC charger eliminates the need for a dual battery switch
Solar Panel Charger
Input voltage12VDC to 26VDC
Power input270W maximum
Control method:MPPC (Max Power Point Control)
Charge voltage14.2VDC
Charging currentDepends on Solar Panel Wattage
Battery Monitor
Voltage Range9.0 to 19.9 Volt
Voltage Accuracy+/- 0.05 Volt
Current Range0.1A to 19.9A
Current Accuracy+/- 0.2A
Optional 220VAC 180W Inverter (R1,530 extra)
Output wave formTrue sine wave
Output voltage220VAC +/-5%
Output power180W continious
450W surge
Input voltage11VDC to 15VDC
Battery Under Voltage Lockout
Lockout voltage10.5 +/-0.25 Volt
Auto turn ON voltage12.5 +/- 0.25 Volt
Manual turn ON voltage> 10.75 Volt
Battery Connection
50A Brad Harrison connector
Outputs
Pump1x 12 Volt 7 Amp maximum Switched
Fridge1x 12 Volt 7 Amp maximum
Lights1x 12 Volt 5 Amp total maximum Switched
Sockets1x 12 Volt 11 Amp total maximum
220 VAC1x 3-pin 220VAC 10 Amp Switched Socket
1x 2-pin 220VAC 10A Euro Switched Socket
1x 220AC 10A IEC Female Socket for MultiPlugs
Inputs
AC220VAC 50Hz 16A max IEC 3-pin socket
VehicleGND, Positive & Ignition(Black, Red & Yellow Power Pole connector)
Solar20A terminal block
HPP1 MK4 R01 Block Diagram
HPP1 MK4 R01 Block Diagram
 
HPP1 MK4 R01 Alternative Wiring
HPP1 MK4 R01 Alternative Wiring
 
HPP1 MK4 R01 Preferred Wiring
HPP1 MK4 R01 Preferred Wiring
 
HPP1 MK4 R01 Correct Wiring
HPP1 MK4 R01 Correct Wiring
 
HPP1 MK4 R01 Wrong Wiring
HPP1 MK4 R01 Wrong Wiring
 
HPP1 Mounting Dimensions
HPP1 Mounting Dimensions